Sensorsoft ST6105J Bedienungsanleitung PDF herunterladen (Seite 30)

Sensorsoft Remote Watchman Express/Client User Manual

Com framing errors: the number of times the software detected a serial communications error: a

bad character was received.

Com overrun errors: the number of times the software detected a serial communications error:

characters came in too fast for the operating system.

Com Rx buffer overflow errors: the number of times the software detected a serial

communications error: characters came in too fast for the operating system.

Invalid response bytes received: the number of times the software received a packet that did not

start with a protocol response byte.

Sensor element tamper bit errors: the number of times the software detected a problem with

the SSD’s sensor. This error should only occur if the sensor is damaged or severely out of

calibration.

Low power supply voltage errors: the number of times the software detected a power supply

voltage that was too low to power the SSD correctly.

Plug and go discoveries: the number of times the software discovers or re-discovers the SSD.

Retry State: the number of times the software has detected a time-out or connection failure.

Critical High state: the number of times the software has detected a reading at or above the

value in the Critical High field, shown on the Sensor Tab.

Critical Low state: the number of times the software has detected a reading at or below the value

in the Critical Low field, shown on the Sensor Tab.

Warning High state: the number of times the software has detected a reading at or above the

value in the Warning High field, but below the value in the Critical High field, shown on the

Sensor Tab.

Warning Low state: the number of times the software has detected a reading at or below the

value in the Warning Low field, but above the value in the Critical Low field, shown on the

Sensor Tab.

Boolean alert state: the number of times the software has detected the Boolean Alert State,

shown on the Sensor Tab.

Return to Normal state: the number of time the software has detected the return to a normal

state after an alert.

Paging failures: the number of times pager notifications failed.

Paging successes: the number of times pager notifications succeeded.

TCP connection failures (RWMC only): the number of times RWMC was unable to connect to

the device server (where SSD is connected).

E-mail failures (RWMC only): the number of times e-mail notifications failed.

E-mail successes (RWMC only): the number of times e-mail notifications succeeded.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Keine Kommentare

Sensorsoft ST6105J Bedienungsanleitung Seite 30